Monday, December 20, 2010

保护你的湿度控制器 Protection for Humidity Controller




如果你的燕屋是使用湿度控制器来控制加湿器的,我会建议你加一个Relay或Contactor来保护您的湿度控制器设备,并延长其寿命。

在市场上有几个不同湿度控制器款式,但其中大多数电路装置都是直接连接到您的加湿器。因为控制器本身不能够携带高电流(最大值〜2A)来供应单个或多个加湿器除非是用Relay或Contactor来携带高电流,就算发生断路也将被隔离,不会伤害到你的控制器。

如果你对电路图不太熟悉,你可以把电路图给承包商去做。这将是很小的花费。你可以给我发电子邮件,如果你有疑问或你的加湿系统配置比较复杂。

If you happen to use humidity controller associated with your humidifiers in your bird farm, I would advise to add a Relay or Contactor to protect your device and also prolong its life span.

There are few different models of humidity controller available in the market, but most of them are made in direct circuit connection to your humidifier device. The controller itself is not able to carry high current(max ~2A) consumed by your single or more humidifier motors unless a Relay or Contactor is used to carry higher current, in case of short circuit it will isolate from reaching your controller device.

If you are not familiar with electrical, you may give the circuit drawing to your contractor to do it. a contact Relay will cost you very minor. you can drop me an email if you have doubt or complicated configuration of your humidity system.

1 comment: